I'm not sure if I should be ripping the whole machine apart and rebuilding each axis again, digging deeper into the control board being the culprit, or looking more into the software settings. See photo:Īs you can see I have exhausted many things and haven't had much luck. Those same sections are being cut too deep instead of leaving too much material. The results weren't good but are almost the opposite as before. Verified X/Y axis movements are accurate to within.Verified depth of cut is accurate to within.Different letters (N and O were most vivid.Tried changing stepover and final pass stepover.Adjusted acceleration in smoothie config to lower numbers than anything I've used before.Tried different speeds & feeds down to painfully slow.Verified V Wheels were all making contact and no abnormal play or slop.So here is what I tried to fix the issue first: Each N was cut with different settings.įirst photo was cut with a whiteside 1541 1/4" 60º V Bit So you can see the top part of the N is leaving that part sticking out. I am hoping someone has seen this before. The board is oriented the same way it would be as if it was sitting on the machine with you in front of it. Here's a picture of the issue I am dealing with. MKS Sbase v1.3 contoller with smoothieware I am having some V-Carve issues and I'm beyond frustrated at this point after significant troubleshooting. Thanks for taking the time to look this over and sorry for the novel.
0 kommentar(er)
